IS415UCVHH1A Product Introduction

  • IS415VCMIH2B – VME communication interface board
  • IS420UCSBH1A – Serial I/O module
  • IS415UCCCH1A – Contact I/O board
  • Mark VI VME backplane assemblies
Category: SKU: IS415UCVHH1A Brand:

Description

IS415UCVHH1A Product Introduction

 

Overview

The IS415UCVHH1A is a VME single-board controller manufactured by GE Vernova for the Speedtronic Mark VI turbine control platform. It functions as the core main processing unit that executes gas/steam turbine control, sequencing, protection and governor logic within the Mark VI VME rack architecture. This CPU board runs real-time turbine application software, handles high-speed closed-loop regulation, and communicates with I/O boards, HMI and plant DCS for coordinated unit operation. This part is obsolete from OEM production and widely stocked as a service spare for outage replacement and legacy Mark VI retrofitsGE Vernova.

IS415UCVHH1A

Key Features & Benefits

  • Low-power Intel Celeron processor built for deterministic real-time control
  • Onboard SDRAM and non-volatile flash memory for application firmware, configuration and fault historian data
  • QNX real-time operating system, optimized for safety-critical power generation control loops
  • Multiple Ethernet communication ports for UDH network, HMI, peer controller sync and plant interface
  • RS-232 serial port for local commissioning, diagnostic access and service terminal connection
  • Precision time synchronization with system communication boards for inter-board timestamp alignment
  • VME64 form factor, directly pluggable into Mark VI VME backplane slots
  • Built-in watchdog timer and fault status LEDs for self-diagnosis and failure indication
  • Rugged conformal-coated PCB design to withstand high EMI, vibration and temperature variation in turbine halls
  • Supports triple modular redundancy (TMR) control configuration for critical turbine protection

 

Technical Specifications

 

Item Description
Manufacturer General Electric / GE Vernova
Model IS415UCVHH1A
Type Mark VI VME Controller CPU Board
Compatible System Speedtronic Mark VI Turbine Control
Processor Intel Ultra-Low-Voltage Celeron
Memory 128 MB SDRAM, onboard flash storage
OS QNX Real-Time OS
Communication Ethernet, RS-232
Bus Interface VME64
Mounting VME rack slot
Operating Temperature 0°C ~ 55°C
Status Obsolete OEM, available as refurbished / surplus spare
Application Gas turbine, steam turbine, combined cycle control & protection

 

Typical Applications

IS415UCVHH1A serves as the primary controller for GE Mark VI turbine control systems in combined-cycle power plants, simple-cycle gas turbines and steam turbine generator sets. It executes fuel control, speed governing, temperature limiting, startup sequencing and turbine protective trips. It is a high-demand spare for planned outages, controller hardware obsolescence replacement and Mark VI system troubleshooting.

 

Matching Companion Boards

  • IS415VCMIH2B – VME communication interface board
  • IS420UCSBH1A – Serial I/O module
  • IS415UCCCH1A – Contact I/O board
  • Mark VI VME backplane assemblies

 

Operation Notes

Firmware revision compatibility must be verified against the existing Mark VI system before swap. Controller configuration, application logic and trip settings require backup and reload after replacement. TMR synchronization and network timing shall be re-validated after installation. Follow GE Mark VI service manual procedures for power cycling and commissioning.

 

FAQ

Q: Is IS415UCVHH1A interchangeable with other Mark VI CPU variants? A: Different Mark VI CPU part numbers carry hardware and firmware differences. Direct replacement is not guaranteed; cross-compatibility must be confirmed by system BOM and application software revision.

Q: Can this board run Mark VIe systems? A: No. IS415UCVHH1A belongs to the classic Mark VI VME platform and is not compatible with Mark VIe distributed control architecture.