Description
Alstom MPS022 VMEbus Power Supply Module
Product Introduction
The MPS022 is a rugged 6U VMEbus hot‑swap power supply module originally designed by Alstom (Converteam), widely deployed within industrial rack‑mounted VME systems. It features active power factor correction (PFC) and accepts wide‑range AC/DC input, delivering three regulated low‑voltage outputs for VME backplane electronics. Built for continuous 24/7 operation, it incorporates overvoltage, overcurrent, overtemperature and short‑circuit protection circuits. Status LED indicators offer straightforward health diagnosis. Its compact 6U form factor supports redundant parallel configuration to improve system uptime for critical control systems. This proven legacy power unit remains a preferred spare part for retrofit, maintenance and replacement of existing VME‑based automation racks.

MPS022
Specification Parameters
| Item | Specification |
|---|---|
| Form Factor | 6U VME module, 19” rack mount |
| Input Voltage | 90–264 VAC; 130–350 VDC |
| PFC | Active Power Factor Correction |
| Output 1 (V1) | 5 VDC, 20 A (UL rated 18 A) |
| Output 2 (V2) | +12 VDC, 4 A (UL rated 3 A) |
| Output 3 (V3) | -12 VDC, 3 A (UL rated 2 A) |
| Total Output Power | Max 100 W, 60 W continuous for ±12V combined |
| Protection | OVP, OCP, OTP, short‑circuit lockout |
| Indication | Front panel status LED |
| Cooling | Conduction + natural convection |
| Operating Temp | 0 °C ~ +40 °C (derate above 40°C) |
| Weight | Approx. 2.5 kg |
| Interface | VME standard backplane connector |
Application Scenarios
- Railway control & signalling rack systems
- Power generation turbine monitoring and protection racks
- Petrochemical DCS and safety control cabinets
- Industrial VME‑based embedded computing platforms
- Marine automation and shipboard control systems
- Defence & test measurement VME chassis
- Legacy Alstom / Converteam drive and controller retrofits
Recommended 10 Related Models
- MPS018
- MPS024
- MPS030
- MPS035
- MPS040
- MPS050
- MPS060
- MPS080
- MPS100
- MPS120
FAQ
Q1: Is MPS022 still in active production? A1: MPS022 is a legacy module, generally end‑of‑manufacture. Most available stock is new surplus or tested refurbished spare units for replacement purposes.
Q2: Can multiple MPS022 run in redundant parallel mode? A2: Yes, it supports redundant configuration for no‑break power supply, commonly used on high‑availability control racks.
Q3: What happens if one output is shorted? A3: The internal protection circuit will latch off the supply to avoid damage to the VME backplane and load modules. Power cycle is normally required for reset after fault removal.
Q4: Does it support hot swap? A4: It is designed as a hot‑swappable VME power supply; follow chassis manufacturer hot‑swap procedures during replacement.
Q5: Can I use it outside the 0–40°C temperature range? A5: Operation above 40°C requires power derating. Continuous operation below 0°C is not recommended without thermal modification.
Q6: Are direct drop‑in replacement alternatives available? A6: Some third‑party VME power supplies offer electrical compatibility, but mechanical pinout and signal timing must be fully verified before substitution.


